Home › Locations › Kenna › Sub Panel Installation

Sub Panel Installation in Kenna, NM

A sub panel gives you more breaker spaces and puts them where you actually need them. Our electricians install sub panels across Kenna, with feeders sized for the load and the distance.

Call (888) 633-7804

Sub panel work we do

Detached buildings are common around Kenna, and each one needs its own properly grounded sub panel with a disconnect. We size the feeder for voltage drop on long runs, trench and install conduit where needed, and separate the neutrals and grounds the way the code requires.

Sub panels for garages and workshops
Power for casitas, guest houses, and additions
Barn, well house, and outbuilding panels
Underground and overhead feeders
Load calculation to confirm the main can support it
Grounding electrodes for detached structures
Clear circuit labeling
Permit and inspection

A sub panel makes sense when

Your main panel has no open spaces
You are adding a shop with welders, compressors, or a kiln
You are building an addition or converting a garage
A detached building needs more than one circuit
You want an EV charger far from the main panel

How we handle sub panel installation in Kenna

Tell us about the job
Call any time and describe what you need. We schedule the visit around your day.
Get a clear price
We look at the work on site and give you a written price before anything starts.
Work done properly
Our electricians complete the job to the New Mexico Electrical Code, with inspections where a permit is required.
Final walkthrough
We show you what was done, test it with you, and leave your home or business tidy.

Why Kenna properties call a local electrician

On the plains of eastern New Mexico, electrical systems around Kenna serve homes, agricultural operations, and industry alike. Long overhead lines, high winds, and severe thunderstorms make surge protection and solid service connections especially important.

Depending on your address, power in Roosevelt County typically comes from Xcel Energy or Roosevelt County Electric Cooperative. When a job involves the meter or the service connection, we coordinate the shutoff and reconnection with the utility.

Our sub panel installation covers all of Kenna, along with neighboring Elida, Pep, Dora, and Floyd.

More electrical services in Kenna

See all 40 electrical services in Kenna

Sub panel installation near Kenna

Statewide details: Sub Panel Installation in New Mexico.

Sub Panel Installation FAQs for Kenna

Sub panel or full panel upgrade: which do I need in Kenna?

If the main service has enough capacity and you only need more spaces or power in a new location, a sub panel is usually enough. If the service itself is too small, you need a panel upgrade. We run the numbers and tell you which.

How big should a sub panel be?

A garage or small shop commonly uses 60 to 100 amps. A casita with its own cooking and cooling may need more. We size it to what you plan to run.

Can you run power to a detached building?

Yes. We trench, lay conduit, pull the feeder, and install the panel and grounding at the building.

Which areas around Kenna do you cover for sub panel installation?

All of Kenna and the surrounding Roosevelt County communities, including Elida, Pep, and Dora.

Need sub panel installation in Kenna?

Call any time. We answer 24 hours a day.