Home › Locations › Mills › Knob & Tube and Aluminum Wiring Replacement
Knob and Tube and Aluminum Wiring Replacement in Mills, NM
If an inspector or insurance company has flagged the wiring in your Mills home, we can help. We confirm what you actually have, explain the options, and carry out the replacement or approved repair.
Your options
Knob and tube has no ground wire and insulation that turns brittle with age, especially where attic insulation has been piled over it. Aluminum branch wiring expands and contracts more than copper, which loosens connections and creates heat. Both are common in older Mills neighborhoods and both can be dealt with.
- Identification of wiring type throughout the house
- Complete knob and tube wiring replacement
- Full aluminum wiring replacement with copper
- Approved aluminum-to-copper connector repair at every device
- Replacement of devices not rated for aluminum
- New grounded circuits for kitchens, baths, and laundry
- Documentation for your insurer or buyer
- Permit and inspection
How to tell what you have
- Ceramic knobs and tubes visible in the attic or crawl space
- Cable jackets stamped AL or ALUMINUM
- A home built before 1940, or between about 1965 and 1975
- Warm cover plates or flickering with no clear cause
- An insurance letter asking about wiring type
Our process for old wiring replacement in Mills
Reach us any time
Phones are answered around the clock. Urgent problems are sent to our emergency electrician.
On-site assessment
We find the real cause, not just the symptom, and lay out your options and their cost.
Repair or installation
You choose how to proceed, and we carry out the work carefully and safely.
Tested and explained
We test everything, label what we touched, and answer your questions before we go.
Local knowledge for Mills, Harding County
On the plains of eastern New Mexico, electrical systems around Mills serve homes, agricultural operations, and industry alike. Long overhead lines, high winds, and severe thunderstorms make surge protection and solid service connections especially important.
Depending on your address, power in Harding County typically comes from your local utility or rural electric cooperative. When a job involves the meter or the service connection, we coordinate the shutoff and reconnection with the utility.
We provide old wiring replacement throughout Mills and in nearby Roy, Solano, Gladstone, and Springer.
More electrical services in Mills
Knob & Tube and Aluminum Wiring Replacement FAQs for Mills
Does aluminum wiring have to be completely replaced?
Not always. Replacing it with copper is the most complete fix. A recognized alternative is to repair every connection in the house with connectors made for joining aluminum to copper. We explain the cost and trade-offs of each.
Is knob and tube wiring illegal in Mills?
Existing knob and tube is not automatically illegal, but it cannot be extended, it should not be buried in insulation, and many insurers will not cover a home that has it. Replacement is the long-term answer.
Will replacing old wiring damage my walls?
We keep openings as few and small as we can by working from the attic and crawl space. Some patching is normal, particularly in plaster and adobe.
Which areas around Mills do you cover for old wiring replacement?
All of Mills and the surrounding Harding County communities, including Roy, Solano, and Gladstone.
Related reading: Knob and Tube and Aluminum Wiring: What New Mexico Homeowners Should Know
Need old wiring replacement in Mills?
Call any time. We answer 24 hours a day.