Dedicated Circuit Installation in Grenville, NM

Circuits we install

A common request in Grenville is a 240 volt circuit for refrigerated air when a home converts from an evaporative cooler. Others include circuits for EV chargers, mini-splits, electric ranges, and garage tools. We size the wire and breaker to the equipment's nameplate.

• Air conditioner, heat pump, and mini-split circuits
• Electric range, cooktop, and wall oven circuits
• Dryer and washer circuits
• Microwave, dishwasher, and disposal circuits
• Freezer and second refrigerator circuits
• Welder, compressor, and table saw circuits
• Well pump and water heater circuits
• Home office and server circuits

You probably need a dedicated circuit if

• A breaker trips when two appliances run together
• You are installing refrigerated air or a mini-split
• An appliance manual calls for its own circuit
• You rely on extension cords or power strips for big loads
• Lights dim when a motor starts

Local knowledge for Grenville, Union County

On the plains of eastern New Mexico, electrical systems around Grenville serve homes, agricultural operations, and industry alike. Long overhead lines, high winds, and severe thunderstorms make surge protection and solid service connections especially important.

Electric service in Union County is typically provided by your local utility or rural electric cooperative. For work on the service entrance or meter, we arrange the disconnect and reconnect with them so you do not have to.

We provide dedicated circuit installation throughout Grenville and in nearby Clayton, Des Moines, Folsom, and Capulin.