Dedicated Circuit Installation in Edgewood, NM

Circuits we install

A common request in Edgewood is a 240 volt circuit for refrigerated air when a home converts from an evaporative cooler. Others include circuits for EV chargers, mini-splits, electric ranges, and garage tools. We size the wire and breaker to the equipment's nameplate.

• Air conditioner, heat pump, and mini-split circuits
• Electric range, cooktop, and wall oven circuits
• Dryer and washer circuits
• Microwave, dishwasher, and disposal circuits
• Freezer and second refrigerator circuits
• Welder, compressor, and table saw circuits
• Well pump and water heater circuits
• Home office and server circuits

You probably need a dedicated circuit if

• A breaker trips when two appliances run together
• You are installing refrigerated air or a mini-split
• An appliance manual calls for its own circuit
• You rely on extension cords or power strips for big loads
• Lights dim when a motor starts

Dedicated Circuit Installation for Edgewood homes and businesses

In the high country around Edgewood, electrical systems have to handle freezing winters, summer thunderstorms, and long rural service runs. Thick adobe walls and historic construction make wiring work slower and call for careful planning.

Depending on your address, power in Santa Fe County typically comes from PNM or a rural electric cooperative. When a job involves the meter or the service connection, we coordinate the shutoff and reconnection with the utility.

We provide dedicated circuit installation throughout Edgewood and in nearby Tijeras, Moriarty, Stanley, and Sandia Park.